Care tips for woodworking engraving machines

The first is to clean the machine surface and the powder and dust on the transmission parts after each use of the wood engraving machine. Regularly add some lubricating oil to maintain the transmission system of the machine. It is important to note that in winter, because the temperature is relatively low, before using the wood engraving machine, it is necessary to clean and then pour the oil into the machine to avoid deformation of the machine due to resistance.

Then the woodworking engraving machine is used for more than 10 hours per day, and there is no interval in the middle. The temperature inside the machine is relatively high. In order not to damage the service life of the machine, it is necessary to ensure sufficient water inside the machine. Water shortage can occur, and in order to avoid burning the machine, it is necessary to change the water regularly to prevent the water temperature from being too high, affecting the use of the machine, and to ensure the cleanness of the water, so that the water pump of the woodworking engraving machine can work normally. It is also important to emphasize that in winter, the temperature is relatively low, so you can change the water in the pump to antifreeze.

Finally, you need to check the machine regularly to see if there is any damage or a serious safety hazard. Before doing this check, be sure to disconnect the power of the machine, wait until the monitor of the machine is not displayed and the indicator light of the main power has been Check it out after it has been extinguished to prevent damage to the machine or threats to life without completely disconnecting the power supply. So completely disconnecting the power supply is something you must do before you do the check.