High-tech has made CNC carpenter carving machine equipment enter various occupations and fields, but the development of equipment is far faster than the development of talents. There are more equipment users, but the operators of real-operated carving machines are few. Less, so it is very simple to present various problems in the daily use process. Like the carpenter carving machine lost these small problems, in fact, master the equipment function is very simple to deal with.
When the sculpt machine is lost, it is not the same as the setting of the computer program when it is carved and embossed. It is a bit tight. Or the carpenter carving machine presents a different heart when engraving, and the knife path gradually goes inside the circle, feeling that the circle is smaller and smaller. This is the lost phenomenon of the carving machine. The main reasons for causing these phenomena are as follows:
(1) The lost machine may be caused by a computer virus. The computer virus or U disk virus may damage the control system program and cause lost steps. The reinstallation of the engraving machine control system is OK;
(2) This problem caused by unstable power supply requires the addition of a regulated power supply;
(3) Loose coupling can also cause the engraving machine to lose the step, check whether the coupling on the engraving machine is loose, and tighten the loose coupling in time;
(4) Carpenter carving machine lost most of the time is the reason for the machine speed setting. It is possible to change settings such as decreasing the feed rate, reducing the amount of each feed, and increasing the spindle speed.
In the final analysis, the CNC carpenter carving machine only needs to be mastered, and generally does not present any problems. The engraving machine is tested for 72 hours in succession before leaving the factory. Unskilled operation is the primary source of fault. In order to better improve the level of CNC engraving equipment in China, and to better serve the processing needs of customers.
